Preparation and materials needed for "Rabbit and Bear Motif"<\/h2>\n\n\n\nYarn and Crochet Hook Size<\/h3>\n\n\n\n
Medium to medium weight cotton thread (gray, white, brown)
Medium-fine cotton thread (black)
3.0 mm (JP 5\/0)
Sewing needle<\/p>\n\n\n\n
Finished size<\/h3>\n\n\n\n
Rabbit: Height 7cm, Width 4.5cm
Bear: Height 3.5cm, width 4.5cm<\/p>\n\n\n\n
Crochet pattern for "Rabbit and Bear Motif"<\/h2>\n\n\n\n
Rabbit (front) knitting pattern<\/a>\u3001Bear (front) knitting pattern,<\/a> Please read the \"Terms of Use<\/a><\/a>\" before using the patterns.<\/p>\n\n\n\r\n\t\t\t\t\t\r\n\t\t\t\t\t\n In addition to the explanation below, please also check the knitting pattern and the explanation with images at the bottom of the page. \u2460Knit the back part of the motif. \u2461Next, knit the front part of the motif. \u2462When knitting the 6th row of the front part of the motif, overlap it with the back part knitted in \u2460 so that they are facing outwards, and sew together using a slip stitch. To make the rabbit ears, work a slip stitch followed by a chain stitch at the position shown in the knitting pattern, then insert the needle into the back of the chain stitch and crochet one double crochet, six double crochets and one double crochet, then work the slip stitch again from the stitch immediately next to the base. Before sewing all the motifs together (stop knitting a little after finishing the ears), embroider the eyes, nose and mouth on the front part. \u2463 Once you have embroidered the face, sew both pieces together to complete the piece. We will start by explaining how to match the motifs on the front and back of the face to the outside and then sew them together.<\/p>\n\n\n\n \r\n\t\t\t\t\t
Rabbit and Bear (Back) Knitting Pattern<\/a>
Face stitching position diagram<\/a><\/p>\n\n\n\nDetailed instructions and steps for making "rabbit and bear motifs"<\/h2>\n\n\n\n
The back of both the rabbit and bear are knitted using the same method.<\/p>\n\n\n\n
Start by making a cast-on loop and knit 6 stitches in the first row. All of the back parts of the motif are knit using knit stitch, increasing stitches each row, until you reach the fourth row.
Please pay attention to the position of the increase stitches in the fourth row.<\/p>\n\n\n\n
Here too, start by casting on a loop and continue knitting by increasing the number of stitches.
Work all the way up to the fourth row in quarter crochets, and then in the fifth row, increase the stitches using quarter crochets and double crochets. Knit both the rabbit and the bear in the same way up to this point.<\/p>\n\n\n\n
Please refer to the explanation with images below on how to sew the pieces together.
In all of the places in the knitting pattern where there are slip stitch symbols, insert the needle through both the front and back of the motif and stitch the slip stitch.<\/p>\n\n\n\n
To make the bear's ears, knit five double crochets in the position shown in the pattern, but insert the needle through the stitches on both the front and back of the motif, and knit the ears with the two pieces together.<\/p>\n\n\n\n
Stitching position of facial features\u56f3<\/a>Please use this as a reference while comparing it with the position of the stitches in the knitting stitches.
If you cut the leftover thread used for embroidery and the ends of the thread from the back part to an appropriate length and stuff it into the three-dimensional part of the nose on the front part, you will not need to use poly batting.<\/p>\n\n\n\n
<\/p>\n\n\n\nPhoto-illustrated explanation<\/h3>\n\n\n\n
![\"\u2460\u5f15\u304d\u629c\u304d\u7de8\u307f\u3092\u7d42\u3048\u305f\u3068\u3053\u308d\u3067\u3059\"](\"https:\/\/ronique.jp\/wp-content\/uploads\/2020\/10\/animal_stitch.jpg\")
<\/figure>
\u2460 I have put the two face motifs, front and back, together with the front sides facing out and have just finished the slip stitch just before the position where I will knit the ears (5 medium double crochets).
Next, insert the needle into the adjacent stitch to create the ear.
<\/p>\n<\/div><\/div>\n\n\n\n
\n\n\n\n<\/figure>
\u2461 Insert the needle into the adjacent stitch and knit 5 double crochets.
<\/p>\n<\/div><\/div>\n\n\n\n
\n\n\n\n<\/figure>
\u2462 I have knitted 5 double crochets. This means I have knitted the first ear.
<\/p>\n<\/div><\/div>\n\n\n\n
\n\n\n\n<\/figure>
\u2463 In the stitches next to where you just knitted the ear (5 double crochets), crochet one slip stitch.
<\/p>\n<\/div><\/div>\n\n\n\n
\n\n\n\n<\/figure>
\u2464 I worked a slip stitch up to one stitch before the position where I would knit the other ear.
<\/p>\n<\/div><\/div>\n\n\n\n
\n\n\n\n<\/figure>
\u2465 Insert the needle into the stitch next to \u2464 and knit an ear (5 double crochets).
<\/p>\n<\/div><\/div>\n\n\n\n
\n\n\n\n<\/figure>
\u2466Continue with the ears and work the slip stitches up to the area shown in the photo above, then it's time to embroider the bear's face.
Once the embroidery is finished, stuff any loose threads into the back of the raised nose and finish by stitching everything through.
<\/p>\n<\/div><\/div>\n\n\n\nYour "rabbit and bear motif" artwork<\/h2>\n\n\n\n
<\/figure>
"Rabbit and bear motif" by yupi*
I'm still a beginner, so I tried again and again before finally completing it!
I attached the finished motif to a hanger that I use often.
All of Ronique's recipes are wonderful, so I want to work hard to improve and be able to make them!
It makes me motivated (^^)
We will continue to update the recipes
looking forward to it!
http:\/\/blog.livedoor.jp\/kondate2010\/archives\/7298733.html<\/a>
<\/p>\n<\/div><\/div>\n\n\n\n